Dr. Fixit Fastflex
Description
Dr. Fixit Fastflex is a two component cementitious coating, composed of high quality cement, properly
selected & graded fillers, additives and liquid polymer. It is suitable for achieving waterproofing for the water
retaining structures such as swimming pools, water tanks, reservoirs, other wet areas, etc, because it provides
strong bonding, good waterproofing and excellent resistant to hydrostatic water pressure by forming highly
elastic seamless coating over the applied concrete or masonry surfaces.
Areas of Application
Any concrete, cement or masonry surface that is subjected to damage from moisture.
Swimming pools, water tanks and reservoirs.
Concrete roofs, basements, and basement walls and lift pits.
Concrete foundations.
Parking decks.
Bathrooms, toilets, sunken portions, balconies, planters, etc.
Podiums.
Features & Benefits 
Elasticity – Highly elastic film formation which accommodates thermal movements.
Permeability – Impermeable to water providing excellent waterproofing property.
Water pressure – High film built-up to withstand 10m hydrostatic pressure without any leakages.
Application advantage – Can be applied on damp surfaces leading to wide range application and instant
remedy from moisture.
Bonding – Excellent adhesion to concrete and masonry substrates hence longer life.
Drying – Quick drying after application & user friendly, faster application.
Seamless coating – Forms seamless coating without any joints, prevents water leakage.
Toxicity – It is Non-toxic and free of VOC.
Ease of application – Easily applied by brush, roller or spray.
Method of Application
1 SURFACE PREPARATION
Surface under treatment should be sound, clean and free from dirt, oil and other loose material
Masonry surfaces should be fully cured (minimum 28 days) prior to application.
All surface cracks, undulations and voids must be repaired appropriately before application
Surface must be in SSD condition prior to application.
2 Mixing
Use slow speed mechanical mixer, add powder component slowly to the polymer in a clean container
Stir till smooth and homogeneous slurry, without any lumps, is achieved
Allow the mixed slurry to stand for 5-10 minutes for releasing trapped air during mixing.
3 APPLICATION
Do not dilute with water
Apply Fastflex slurry by brush, roller or trowel.
Allow the slurry to dry completely for 6-8 hrs before applying 2nd coat.